My first mistake was downloading the wrong instructions (v1.0) since the unit I received did not have any identification on the unit or on the invoice. I assumed (v2.0) with LED's did not apply since my unit had no visible LED's on it.
I did not discover my mistake until I had completed the first 13 steps of the (v1.0) installation. Then I realized I had no set screws to fasten down the wires on my unit.
I then tried to reverse the installation, as it was getting dark and the project had to be aborted for the night, however I accidentally reversed the yellow and black wire locations as shown in step 6. That prevented me from even starting the car. I went back into the module and changed the black wire with the yellow wire locations and the car started.
The next day I downloaded instructions v2.0 and reinstalled the
remote key. However after the installation, the car did not chirp twice as proof that the installation was successful. I then uninstalled the unit again, leaving only the power tap clips in place.
The car now is:
1. Key Fob locks the passenger door with one chirp (even without the
remote key in place?)
2. Driver door must be key locked and unlocked
3. Both windows do not work
4. Alarm button on central dash does not work
5. System fault light is ON
6. Airbag light is ON
7. Car starts and drives without any other problems
I'll pass this description along to Sven.
3.
Linear Mode
